assembly instructions
Item No. 3664
1. Find a clear area in which you can work.
2. Unpack xture and glass from carton.
3. Carefully review instructions prior to assembly.
3664
*** The construction of this xture will be accomplished by rst assembling the main body,
hanging the xture, and then installing the xture glass.
2
3
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
6.1.12
Drawing 1 - Fixture Assembly
12
HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
1. To install glass, slip center hole of glass (4) onto locator disc (3), located at the
base of the adjustable center stem (2), of the cental assembly (1). Hold glass in
position - see Drawing 3.
2. While holding glass (4) slip cap (5) onto center stem (2) and hold in postion.
3. Thread on hexnut (6) onto center stem (2) and thighten to secure glass to fixture.
4. Slip decorative cap (7) onto center stem.
5. thread knob (8) onto end of center stem (2) and tighten to complete assembly.
1
2
7
5
3
4
6
8
1. The main body assembly and be mounted to the ceiling prior to attaching the glass.
Please follow instruction sheet (IS19-91) provided.
2. After fixture is installed please return to this section for instructions on how to install
the glass.
Comments to this Manuals