Hinkley-lighting CONGRESS 3136 User Manual download pdf

assembly instructions

Item No. 3136

1. Find a clear area in which you can work.

2. Unpack xture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this xture will be accomplished by rst determining the length of

stem required, mounting the attaching strap to the junction box, making all necessary

elctrical connections, hanging the xture from the ceiling, and then installing the glass.

start here

Note: Maximum wattage for 3117 xture is 100 watts per bulb.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

1. Determine the overall length you will need the assembled xture to be.

2. Determine what stems will be needed to achieve the overall length you require.

(Additional stems are available and can be ordered. Ask your local Hinkley Lighting representa-

tive or visit www.hinkleylighting.com for information.)

3. Install stems by slipping them onto the supply wire of the xture, threaded end up, and

threading them together -see Drawing 3.

Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.

18) and follow all instructions to make all necessary wiring connections. Then refer back to this

sheet to continue installation of this xture.

1. Install screws (A) into mounting plate (B) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (D)

in the canopy (E) - see Drawings 1 and 2.

2. Attach mounting plate (B) to junction box (J), using screws (G) provided and then slip supply

wires through large center hole.

1. Hang the xture by slipping canopy (D) over screws (B) in the mounting strap - see Drawing 2.

2. Thread on ball knobs (E) onto the end of screws (B) and tighten to secure xture to ceiling.

1. To install glass, unthread knurled knob (2) in bracket (1) until glass can slip into brackets - see

Drawing 3.

2. Lamp xture accordingly at this point.

3. Slip glass (3) into brackets (1) and hand tighten knurled knobs (2) to secure glass.

Drawing 2 - Fixture Mounting

Drawing 1 - Strap Detail

Drawing 3 - Glass Installation

01.01.12

stems

wire

HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5553 hinkleylighting.com

Item No. 3136 1

Summary of Contents

Page 1 - Item No. 3136

assembly instructions Item No. 31361. Find a clear area in which you can work.2. Unpack xture and glass from carton.3. Carefully review instruct

Comments to this Manuals

No comments

Hinkley-lighting CONGRESS 3136 User Manual

Browse online or download User Manual for Lighting Hinkley-lighting CONGRESS 3136. Hinkley Lighting CONGRESS 3136 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Hinkley-lighting CONGRESS 3136