Hinkley-lighting MIRA FIZZ FR55453PCM User Manual

Browse online or download User Manual for Lighting Hinkley-lighting MIRA FIZZ FR55453PCM. Hinkley Lighting MIRA FIZZ FR55453PCM User Manual [ru]

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
FR56563PCM, FR54343PCM, FR55453PCM
MIRA
[DRAWING 1]
[DRAWING 2]
Bulbs: 60 W g9
5.28.10
800.421.35 17 WWW.F RE DRI CKRAMON D.COM
a
1
3
2
f
d
c
g
b
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first installing the mounting strap to
the junction box, making all necessary electrical connections, mounting the fixture to
the wall and then installing the fixture glass.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 Remove ball knob (c) from front of backplate (d) - See Drawing 1.
2 Remove retainer plate (a) from backplate (d).
3 Attach retainer plate (a) to junction box using two 8-32 screws (b).
4 Additional screws can be installed at points (e) for additional mounting support.
Please use appropriate anchor for material the fixture is being mounted too.
5 Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.
6 Slip holes (g) in backplate (d) over screws (f) on retainer plate (a).
7 Thread ball knobs (c) onto end of screws (f) and tighten to secure backplate to
wall.
STEP 2
1 Install panel glass (1) on backplate by slipping it over the sockets (2) and thread
ing on the socket rings (3). HAND TIGHTEN ONLY until snug. Over tightening
using a tool could cause the glass to crack - See Drawing 2.
2 Fixture can now be lamped accordingly and thread bulb shield onto socket
after lamping.
3 To attach decorative glass assembly, slip mounting knobs (5) into key slots (6)
located on the backplate. After engaging all four of the knobs, gently pull down on
the decorative glass assembly to lock them in the keyslot.
6
5
Page view 0
1

Summary of Contents

Page 1 - ASSEMBLY INSTRUCTIONS

FR56563PCM, FR54343PCM, FR55453PCMMIRA[DRAWING 1][DRAWING 2]Bulbs: 60 W g9 5.28.10800.421.35 17 WWW.F RE DRI CKRAMON D.COMa132fdcgb

Comments to this Manuals

No comments