Hinkley-lighting PANDORA FR42407BRC User Manual download pdf

FR42407BRC

PANDORA

ASSEMBLY INSTRUCTIONS

Assembly of this ﬁxture will be accomplished by ﬁrst determining the length of stem

required, attaching the mounting strap to the junction box, making all necessary electri-

cal connections, hanging the ﬁxture from the ceiling and then installing the ﬁxture glass.

SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply oﬀ during installation. If new wiring is

required, consult a qualiﬁed electrician or local authorities for code requirements.

STEP 1

1 Determine the overall length you will need the assembled ﬁxture to be.

2 Determine what stems will be needed to achieve the overall length you

require.(Additional stems are available and can be ordered. Ask your local

Fredrick Ramond representative or visit www.fredrickramond.com for

information.

3 Install stems (C) by slipping them onto the supply wire of the ﬁxture,

threaded end down, and threading them together. the ﬁrst stem is

threaded into coupler (A) at the top of the ﬁxture. Continue adding stems

until determined length is achieved.

STEP 2

1 Prepare mounting strap (a) by threading the two longest screws (b) into the

back

of the mounting strap (a), making sure the holes into which the screws are

threaded match the spacing of holes (d) in the backplate (e) - See Drawing 2.

2 Attach mounting strap (a) to junction box (j) using two screws (c).

3 Make electrical connections from supply wire to ﬁxture lead wires. Refer to

instruction sheet [FRIS18] and follow all instructions to make all necessary

wiring connections. Then refer back to this sheet to continue installation of

this ﬁxture.

4 To mount ﬁxture, slip the two mounting screws (b) through the two moun

ing holes (d) in the backplate (e).

5 While holding ﬁxture in place, thread the two ball knobs (f) on to the end of

the mounting screws (b), and tighten.

STEP 3

[DRAWING 2]

[DRAWING 3]

Bulbs: 60W CAND. Replacement Parts: SHADE: R42400SH

11.18.09

800.421.3517 WWW.FREDRICKRAMOND.COM

[DRAWING 1]

Fixture can be lamped accordingly at this point. It is recommended that ﬂame

tip candlelabria bulbs NOT be used, since the ﬂame tip may interfer with the

shade setting properly on the ﬁxture - see Drawing 2.

To attach shade (1) turn shade so inside bulb clip (s) is perepndicular to the

outside of the ﬁxture. Spread bulb clip (s) and slip onto bulb. Shade can now

be adjusted.

See Drawing 2 1

Summary of Contents

Page 1 - See Drawing 2

FR42407BRC PANDORA ASSEMBLY INSTRUCTIONS Assembly of this ﬁxture will be accomplished by ﬁrst determining the length of stem required, attaching t

Comments to this Manuals

No comments

Hinkley-lighting PANDORA FR42407BRC User Manual

Browse online or download User Manual for Lighting Hinkley-lighting PANDORA FR42407BRC. Hinkley Lighting PANDORA FR42407BRC User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Hinkley-lighting PANDORA FR42407BRC