Hinkley-lighting HARBOR 2576 User Manual download pdf

assembly instructions

Family: Harbor Item No. 2576

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

1. To install mounting bracket, determine location where mounting bracket is to be

mounted to pier, and mark hole location. - see Drawing 1.

2. Drill 3/8” diameter hole, 1-3/4” deep with a masonry drill at marked locations.

3. Tap mounting bolts (1) with sleeve into drilled holes, sleeve end ﬁrst.

4. Place mounting bracket (2) over bolts.

5. Place washer (3) followed by lockwasher (4) onto all of the bolts.

6. Thread hex nut (5) onto bolts and tighten.

Note: Bolts provided are for mounting in concrete or stone. If mounting to any other

type of material use an appropriate fastener.

1. To lamp ﬁxture or replace glass, remove the two ball knobs (7) from under the roof

(8) - see Drawing 2.

2. Lift roof (8) off of ﬁxture.

3. Fixture can now be lamped accordingly.

To replace glass: unscrew round head screws (9) and remove upper half of main body

(10). Glass can now be replaced. Then replace upper half of main body (10) and secure

with round head screws (9).

4. Replace roof (8) and thread ball knobs (7) onto ﬁxture.

*** The construction of this ﬁxture will be accomplished by ﬁrst installing mounting

bracket to pier, making all necessary electrical connections, mounting ﬁxture to pier

and then lamping ﬁxture accordingly.

start here

2576

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 - Fixture Mounting

Drawing 2 - Fixture Assembly

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections. Then

refer back to this sheet to continue installation of this ﬁxture.

1. To mount ﬁxture to bracket, slip base of ﬁxture over mounting bracket, making sure

that the screw holes on the side of the base and the ends of the mounting bracket

line up - see Drawing 2.

2. Slip ﬂat head screw (6) through the base and thread into mounting bracket.

12.1.09

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1 2

Summary of Contents

Page 1 - Drawing 2 - Fixture Assembly

assembly instructionsFamily: Harbor Item No. 2576 1. Find a clear area in which you can work.2. Unpack ﬁxture and glass from carton.3. Carefully

Page 2

I.S. 18 wiring grounding instructionsSAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPL

Comments to this Manuals

No comments

Hinkley-lighting HARBOR 2576 User Manual

Browse online or download User Manual for Lighting Hinkley-lighting HARBOR 2576. Hinkley Lighting HARBOR 2576 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Hinkley-lighting HARBOR 2576