Hinkley-lighting CELESTE FR42642SLF User Manual download pdf

FR42642SLF

CELESTE

ASSEMBLY I N STRUC T IONS

Assembly of this ﬁxture will be accomplished by ﬁrst installing the mounting strap to

the junction box, making all necessary electrical connections, mounting the ﬁxture to

the wall, and then installing the crystal and ﬁxture glass.

SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply oﬀ during installation. If new wiring

is required, consult a qualiﬁed electrician or local authorities for code requirements.

STEP 1

STEP 4

Slip glass (3) over socket (s) - See Drawing 2.

3 Slip socket cover (4) over socket (S) making sure ﬂat washer is facing down. Making

sure small tube on bottom of sleeve slips through bottom hole in glass.

4 Fixture can now be lamped accordingly.

[DRAWING 1]

[DRAWING 2]

Bulbs: 60W CAND. Replacement Parts: GLASS: FR42640gl, fR42640CRY

6.01.11

80 0.4 21 . 35 17 W WW.F R EDRIC K RA M O N D.C OM

To install crystal (1) thread end into end of stem (2) until snug or in appropriate position.

1 Prepare mounting strap (a) by threading tube into the center hole of

the mounting strap (a), approximately 1/4“- see Drawing 2.

2 Attach mounting strap (a) to junction box (j) using two screws (b) provided.

Make electrical connections from supply wire to ﬁxture lead wires.

Refer to instruction sheet (I.S. 18) and follow all instructions to make all necessary

wiring connections. Then refer back to this sheet to continue installation of this ﬁxture.

STEP 2

1 To mount backplate to wall, slip center hole of backplate (e) over nipple (c) and

hold ﬁxture in position - see Drawing 2.

2 Thread decorative knob (d) onto end of nipple (c) and tighten to secure ﬁxture.

STEP 3

Page 1

FR42642SLFCELESTEASSEMBLY I N STRUC T IONS Assembly of this ﬁxture will be accomplished by ﬁrst installing the mounting strap to the junction bo

No comments

Hinkley-lighting CELESTE FR42642SLF User Manual