Hinkley-lighting VIRGINIAN 5127PB User Manual download pdf

#5127 ASSEMBLY I.S. 98

Place lockwasher (3) over end of tube (1) having the upset (2). Place end of tube, with upset, through

large hole of bottom body (4) (bottom body has eight of the largest arms attached to it) and out the small

bottom hole. Screw loop (5) on to end of tube. Be sure loop is tight!

Lower column (7) over tube (1) with wider/open end of column pointing toward bottom body (4).

Before resting column on bottom body, push wire connectors (6) together until you hear them click. Rest

column on bottom body; make sure bottom of column checks inside the large hole of the bottom body and

the top of the tube goes through the center hole in the top of the column.

Thread wire connector (8) through side hole, not center hole, in cap (9) and middle body (10)

(middle body has eight middle-sized arms attached to it). Stack the cap and body on top of column. Make

sure that top of tube (1) goes through center holes

of cap and middle body.

Place lockwasher (11) inside body (10) over

13 17 top end of tube (1).

Screw tube (13), with hex-coupler (12) on to

top end of tube (1). USE PLIERS TO TIGHTEN THIS

TUBE!

12 14 Make wire connection (14) between wire con-

nector (8) and either one of the two connectors

11 coming from the middle body. Push connectors to-

gether until you hear them click.

10 Turn large arms (15) 90 degrees so that the

light sockets point up.

9 16 Turn medium arms (16) 90 degrees so that the

light sockets point up.

Go to other side...

1 2 3 4

Page 1

#5127 ASSEMBLY I.S. 98 Place lockwasher (3) over end

Page 2

30 29 28 27 26 23 31 24 25 22 20 21 19 18

start hereDrawing 1 - Hanging AssemblyI.S.19 hanging instructionsI.S. 1912A4B5C6weave supply wire andground wire through chainDrawing 2 - Canopy Adj

Page 4

HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.comI.S. 18 wiring grounding instr

Related models: VIRGINIAN 5127PW

No comments