Hinkley-lighting PULLMAN 3257 User Manual download pdf

1. Shut off electrical current before starting. If the ﬁxture you are replacing is

turned on and off by a wall switch, simply turn the switch off. If not, remove

the appropriate fuse (or open the circut breakers) until the ﬁxture is dead.

• DO NOT restore current - either by fuse, breaker or switch - until the new

ﬁxture is completely wired and in place.

1. Determine the desired height the chandelier will be installed at.

2. The ﬁxture is supplied with a variety of stem lengths. Determine what combination

of stems are needed to achieve desired length - see Drawing 1.

3. Slip stems over wire and thread ﬁrst stem onto top of chandelier. Repeat this process

until all required stems are threaded together.

4. Slip wire through center of canopy swivel and thread onto stem assembly.

start here

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 - Fixture Assembly

Drawing 2 - Fixture Assembly

Assembly Instructions

3257

stem

wire

stem

HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting

plate (B) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (C)

in the canopy (1).

2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip

supply wires through large center hole.

1. Hang the ﬁxture by slipping canopy (D) over screws (B) and holding in position - see

Drawings 1.

2. Thread ball knobs (E) onto end of screws (B) and tighten to secure ﬁxture to ceiling.

06.01.13

Item no. 3257

1 2

Assembly Instructions 1

Summary of Contents

Page 1 - Assembly Instructions

1. Shut off electrical current before starting. If the ﬁxture you are replacing is turned on and off by a wall switch, simply turn the switch off. If

Page 2

HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.comI.S. 18 wiring grounding instr

Comments to this Manuals

No comments

Hinkley-lighting PULLMAN 3257 User Manual

Browse online or download User Manual for Lighting Hinkley-lighting PULLMAN 3257. Hinkley Lighting PULLMAN 3257 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Hinkley-lighting PULLMAN 3257