assembly instructions
Family: Key West Item No. 1611 RB
1. Find a clear area in which you can work.
2. Unpack xture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Fixture can be lamped accordingly at this time.
2. To assembly xture line up holes (2) in roof assembly (1) with studs (4) locted atop cage
assembly (5).
3. Thread ball knobs (3) onto end of stud (4) to secure roof to xture.
*** The construction of this xture will be accomplished by rst assembling
main body of the xture, making all necessary electrical connections, then mounting the
xture to pre-installed post .
start here
1611
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this xture.
Drawing 2 - Fixture Mounting
Drawing 1 - Fixture Assembly
1. After wiring connections are complete, slip post tter (A) over top of pre-installed post (B)
making sure all wire connections are tucked inside the pole - see Drawing 2.
2. When xture is slipped over pole make sure no wires are being pinched between the top edge
of the pole and the inside of the post tter.
3. Thread the 3 set screws (C) into pre-tapped holes in post tter.
4. Tighten screws (C) to secure xture to post.
1
4
2
3
5
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
Comments to this Manuals