assembly instructions
Family: Grayson Item No. 2030/2034
1. Find a clear area in which you can work.
2. Unpack xture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this xture will be accomplished by rst attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the xture to the wall, and then installing the glass.
start here
2034
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 2030/2034 xture is 100 watts per bulb.
Drawing 1 - Fixture Mounting
Drawing 2 - Glass Installation
Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this xture.
01.01.12
2030
A
J
B
F
F1
C
D
E
1. Prepare mounting strap (A) by threading threaded tube (C) into the center hole
of the mounting strap (A), approximately 1/4” - see Drawing 1.
2. Attach mounting strap (A) to junction box (J) using two short screws (C) provided.
3. Slip lock washer (F1) over nipple (C) and thread hex nut (F) onto threaded tube (C).
4. Hex nut (F) can be tightened against mounting strap (A) after adjusting threaded
tube (C) to proper mounting length.
6. Thread decorative knob (D) onto end of threaded tube (C) and tighten to secure
5. To Mount xture to wall slip center hole of backplate (E) over the threaded tube (C)
and hold xture in position.
xture.
1. Prior to installing glass xture can be lamped accordingly.
2. To install glass (2), slip into glass holder (GH).
3. Thread in retaining screws (1) into side of glass holder (GH), and tighten.
NOTE: hand tighten only.
44
3
2
1
1
2
GH
Comments to this Manuals