Hinkley-lighting CAPE COD 2202 User Manual download pdf



assembly instructions

Family: Cape Cod Item No. 2202 SZ/GM

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

1. The top assembly of the ﬁxture comes assembled. In order to assemble the ﬁxture

the following must be taken apart: remove center tubing (2) from cone (3) by remov-

ing cap (5) - see Drawing 1.

2. Slip center tubing (2) onto supply wire and thread into coupler (A) on top of the

main body (1), approximately 3/8”.

3. Tighten hex nut (B) against coupler (A) to lock center tubing in place.

4. Slip cone (3) over supply wire and onto tubing (2).

5. Adjust hex nut (C) so it touches the inside top of the cone (3) when base of cone

touches the top of the ﬁxture body.

6. Slip decorative check ring (4) over supply wire and onto center tubing (2).

7. Slip ring (5) over supply wire and onto center tubing (2).

8. Thread top cap (6) over supply wire and onto center tubing (2) and tighten.

9. Spread hanging ring (7) and slip over ring (6) and close gap in ring (7) to prevent it

from slipping off the ﬁxture and attach chain to ring (7).

10. Please refer to hanging Instruction Sheet (I.S. 19) provided to hang ﬁxture.

*** The construction of this ﬁxture will be accomplished by ﬁrst assembling the

the main body of the ﬁxture, making all necessary electrical connections, and

then hanging the ﬁxture from the ceiling.

start here

2202

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.



Drawing 1 - Fixture Assembly

3.27.08

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1 2

assembly instructionsFamily: Cape Cod Item No. 2202 SZ/GM 1. Find a clear area in which you can work.2. Unpack ﬁxture and glass from carton.3. C

Page 2

I.S. 18 wiring grounding instructionsSAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPL

No comments

Hinkley-lighting CAPE COD 2202 User Manual