assembly instructions
Family: Camelot Item No. 1701 / 1707 BK
1. Find a clear area in which you can work.
2. Unpack xture and glass from carton.
3. Carefully review instructions prior to assembly.
1. To assemble main body, slip break (1) over nipple (2) - see Drawing 1.
2. Thread nial (3) onto nipple (2).
*** The construction of this xture will be accomplished by assembling the main body,
making all necessary electrical connections, and then mounting the xture to pre-installed
post.
start here
1707
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this xture.
Drawing 2 - Fixture Mounting
Drawing 1 - Fixture Assembly
1
2
3
5
1. After wiring connections are complete, slip post tter (A) over top of pre-installed post (B)
making sure all wire connections are tucked inside the pole - see Drawing 2.
2. When xture is slipped over pole make sure no wires are being pinched between the top edge
of the pole and the inside of the post tter.
3. Thread the 3 set screws (C) into pre-tapped holes in post tter.
4. Tighten screws (C) to secure xture to post.
5. Fixture can now be lamped accordingly.
1. Fixture is mounted using 3 - 1/4-20 set screws.
2. Make all necessary electrical connections following wiring instructions below.
2.7.08
1701
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
Comments to this Manuals